Medina, King County
Creosote removal in Medina starts from $245 and goes up with how hard the deposit is. Loose, flaky buildup comes off with a normal sweep. Thick tar or a shiny glaze stuck to the flue walls does not, and that is the job this service covers.
Typical investment
From $245
Book an inspection
Book your $99 inspection
$99 plus tax, deducted when you approve the repair
Not sure where to start
Pick what you're seeing at your Medina home — we'll point you to the right fix.
What we do
The same crew, the same written quote — for Medina homes.
Level 1 or Level 2 inspection, with a camera scan where warranted
Learn more
Complete sweep of the flue and firebox, protected by drop cloths and HEPA filtration
Learn more
Restoration of brick, mortar joints and firebox
Learn more
A stainless-steel or ceramic liner run the full height of the flue
Learn more
A stainless cap fitted to your flue's exact dimensions
Learn more
Cleaning of the burner, pilot and valve assembly
Learn moreRanges shown for orientation — the exact figure is written up on-site, after the inspection.
A Medina fireplace that is lit only for a few cold weekends or a holiday can still build up heavy creosote. Short fires with damp wood burn cool, and cool smoke condenses on the flue walls instead of leaving the chimney. The damp western Washington winter makes the problem worse: firewood left uncovered outside is hard to keep dry between October and spring.
Medina is a city of single-family homes only, and HistoryLink describes its long appeal for large, substantial houses on spacious lots. In a house with more than one fireplace, the one used a few times a year is often the one with the worst creosote, because its fires are short and cool.
CSIA's Level 2 procedure checks all flues within a chimney and the appliances connected to them. We take the same approach when grading creosote: every flue in the stack gets a camera, since a clean flue next to a glazed one is common and the price depends on each.
Medina's land runs along Lake Washington, the biggest of King County's three major lakes. An exterior chimney on an exposed lot loses heat to the wind, and a cold flue lets smoke cool and condense sooner.
Western Washington's strongest winds, per the Western Regional Climate Center, come mainly from southerly directions in late autumn and winter, the same months fireplaces get used. A flue on the exposed side of a house can run colder than one on the sheltered side, which is one reason we grade each flue on its own.
Every creosote removal we do in Medina includes:
Smoke coming back into the room, or a smell that won't go? Book the inspection first.
Book nowWe usually find two patterns. One is a flue that has not been cleaned in years, where layers have hardened into glaze. The other is a fireplace with a closed-off or poorly drawing flue, where smoke lingers long enough to leave tar behind. Both raise the risk of a chimney fire, and both need more than a brush.
A camera shows how far the deposit reaches and whether it is flaky, tarry or glazed.
The written quote reflects the grade we saw; lighter deposits cost less than full glaze.
We use rotary tools for hardened layers and a treatment for glaze that resists them, with the room fully sealed.
A second camera pass records the cleaned flue so you can see the difference.
What this work is quoted at for Medina homes — the exact figure comes from the $99 on-site inspection, credited toward the work.
| Service | Price in Medina | What that covers |
|---|---|---|
| Creosote Removal | From $245 | Priced by creosote stage — glazed stage 3 is the heavy end |
| Chimney Sweep | $189–$449 | Full flue swept, Level 1 inspection included |
| Chimney Inspection | $99 plus tax | Level 1 visual; Level 2 adds a full camera scan |
| Chimney Relining | From $1,895 | Full-length stainless liner, sized to the appliance |
| Chimney Repair | From $425 | Masonry repair — brick and mortar, scoped after diagnosis |
Ranges are what these jobs are quoted at in Medina. The exact figure is set on site after a $99 inspection (credited toward the job if you go ahead), and you approve it before any work starts.
Under Puget Sound Clean Air Agency rules, the only fuel allowed is dry, seasoned wood or manufactured logs, and damp wood is also what leaves the heaviest tar. Keeping a woodpile dry is hard here: the Western Regional Climate Center reports frequent rain through December and January, with January humidity typically bottoming out around 78 percent in the afternoon.
Water also reaches the flue itself when the cap, crown or flashing fail, all items CSIA lists as basic protection. A damp flue stays cool longer after each fire, which helps creosote build. When we remove a heavy deposit, we also note where water may be getting in.
Medina is an exclusive lakefront enclave with some of the region's most valuable estates, on Lake Washington, with large waterfront and estate homes.
MedinaKing County, WA · 47.621, -122.227
Before and after
Illustrations of what each repair changes on a typical chimney — not photos of a specific job.
Before
After
Before
After
Before
After
Four steps, each one on paper — so you always know what happens next.
Choose a genuine opening on the crew's calendar. Confirmation is immediate.
Liner, crown, cap, flashing and masonry examined in order — each finding photographed.
One document, plain numbers, covering only the work your chimney genuinely needs.
The repair is completed, then handed over with before-and-after photos of every item.
From $245. Light hardened buildup is near that figure; thick glaze needing several treatments costs more, and the quote tells you which you have.
Yes. It is flammable, and a heavy deposit is the usual fuel of a chimney fire. Once a flue has had a fire in it, the Chimney Safety Institute of America's advice is a Level 2 inspection.
We look with a camera. The on-site inspection is $99 plus tax, and it is credited toward the work when you approve the written quote.
A $99 on-site inspection, a written quote before any work, and photos of every item we touch.
