Bellevue Chimney Pros logo

Issaquah, King County

Masonry Repair (Crown / Repointing) in Issaquah, WA

Chimney masonry repair in Issaquah starts at $475, covering crown work and repointing. A crown patch or a few courses of joints sit near the start of the range; a full crown rebuild or repointing the whole stack costs more, and both are priced from measurements taken on the roof.

Typical investment

From $475

  • Serving Issaquah and the rest of our King County territory
  • $99 plus tax on-site inspection, credited toward an approved quote
  • Usually on the same route as Bellevue, Clyde Hill, Medina
  • Local crews
  • Licensed & insured
  • Documented work
  • Written quote first

Book an inspection

Book your $99 inspection

$99 plus tax, deducted when you approve the repair

Service
Town

Book your $99 inspection

Pick a real open slot on our crew's calendar — takes about a minute.

  • No payment to book
  • Written on-site quote
  • Photos of every job
  1. 1
  2. 2
  3. 3
  4. 4

Masonry Repair (Crown / Repointing) in Issaquah

Pick a date
October 2026
Su
Mo
Tu
We
Th
Fr
Sa
Open times

Loading open times…

Not sure where to start

What's going on with your chimney?

Pick what you're seeing at your Issaquah home — we'll point you to the right fix.

What we do

Other chimney services in Issaquah

The same crew, the same written quote — for Issaquah homes.

Ranges shown for orientation — the exact figure is written up on-site, after the inspection.

Why Issaquah homes need masonry repair (crown / repointing)

The crown is the concrete or mortar slab that caps the brick, and it takes more rain than any other part of the chimney. Many crowns around Issaquah were poured flush with the brick, with no drip edge, so water runs straight down the face instead of falling clear. Over years that shows up as eroded joints just under the top.

Your masonry repair (crown / repointing) in Issaquah: what's included

Every masonry repair (crown / repointing) we do in Issaquah includes:

  • Crown repaired or rebuilt with drip edge
  • Worn mortar ground out to depth
  • Joints refilled with matched mortar
  • Loose or broken brick reset
  • Masonry cleaned after the work
  • Written scope with measurements

Signs you need masonry repair (crown / repointing) in Issaquah

  • Mortar you can scrape out by hand
  • Crown cracked or crumbling
  • White deposits on the brick face
  • Dark patches that stay wet for days
  • Bits of mortar in the gutter

Smoke coming back into the room, or a smell that won't go? Book the inspection first.

Book now

Why Issaquah homes need it

Repointing requests here usually follow a winter of heavy rain: mortar that has gone sandy and can be scratched out with a key, dark wet patches on the brick that linger for days, and white mineral deposits on the face. Grinding out the worn mortar and refilling it restores the joints before the brick itself starts to fail.

Your masonry repair (crown / repointing) in Issaquah, step by step

  1. 1

    Measure crown and joints

    We measure the crown, check its overhang and map which faces of the stack have worn joints, since exposure is rarely the same on all four sides.

  2. 2

    Remove the failed material

    Loose crown material is broken out and worn mortar is ground back to sound depth, so new work bonds to solid masonry rather than to crumbs.

  3. 3

    Rebuild and repoint

    The crown is formed with a drip edge that clears the brick, and the joints are packed and tooled to match the existing profile.

  4. 4

    Cure and clean up

    We clean mortar smears off the brick and explain how long the new work needs before it faces heavy rain.

Masonry Repair (Crown / Repointing) prices in Issaquah

What this work is quoted at for Issaquah homes — the exact figure comes from the $99 on-site inspection, credited toward the work.

Masonry Repair (Crown / Repointing) prices in Issaquah — published rates, 2026
ServicePrice in IssaquahWhat that covers
Masonry Repair (Crown / Repointing)From $475Crown work, repointing and tuckpointing by surface area
Chimney Sweep$189–$449Full flue swept, Level 1 inspection included
Chimney Inspection$99 plus taxLevel 1 visual; Level 2 adds a full camera scan
Chimney ReliningFrom $1,895Full-length stainless liner, sized to the appliance
Chimney RepairFrom $425Masonry repair — brick and mortar, scoped after diagnosis

Ranges are what these jobs are quoted at in Issaquah. The exact figure is set on site after a $99 inspection (credited toward the job if you go ahead), and you approve it before any work starts.

Why crowns wear out fast in Issaquah's damp air

The Chimney Safety Institute of America recommends that a crown project roughly two inches past every side of the chimney, so rain drips clear instead of washing over the brick and mortar below. A flat, flush crown skips that protection entirely.

Western Washington's climate record shows why the detail matters. The wet season opens in October, and January air stays damp around the clock, near 87 percent relative humidity in the small hours and still about 78 percent by mid-afternoon. Masonry that gets soaked on the surface has little chance to dry, so joints erode steadily through the cool months.

Around Issaquah

Issaquah is a city nestled against the Issaquah Alps, with a historic downtown plus large newer developments in the highlands. We work every part of it — Gilman, Issaquah Highlands, Squak Valley included.

IssaquahKing County, WA · 47.530, -122.033

Before and after

What the work changes

Illustrations of what each repair changes on a typical chimney — not photos of a specific job.

A Bellevue Chimney Pros technician pointing to the four steps of a visit

From booking to done

Four steps, each one on paper — so you always know what happens next.

  1. 1

    Book online

    Choose a genuine opening on the crew's calendar. Confirmation is immediate.

  2. 2

    On-site inspection

    Liner, crown, cap, flashing and masonry examined in order — each finding photographed.

  3. 3

    Written quote

    One document, plain numbers, covering only the work your chimney genuinely needs.

  4. 4

    Work done & documented

    The repair is completed, then handed over with before-and-after photos of every item.

Masonry Repair (Crown / Repointing) in Issaquah — common questions

What does masonry repair cost in Issaquah?

From $475. The price depends on how much crown needs rebuilding and how many square feet of joints need repointing. You get it itemized before we start.

Can you just seal the cracks in my crown?

Hairline cracks can be sealed. A crown that is breaking apart, or one with no overhang at all, lasts longer if it is rebuilt properly.

How do I know what's causing the damage?

Book an inspection. The on-site inspection is $99 plus tax, and it is credited toward the work when you approve the written quote.

Get in touch

Book an inspection

Need your chimney checked in Issaquah?

A $99 on-site inspection, a written quote before any work, and photos of every item we touch.

Call (425) 380-8866Book